ATV Torture Forums banner

Welcome to the board, EssexMfg.

2276 Views 4 Replies 4 Participants Last post by  steveft
ATVTorture would like to welcome our newest member, EssexMfg.

Welcome aboard! :hello:
1 - 5 of 5 Posts
Thanks ya'll! :eek:ccasion14:
As for what we do; we make quality accessories for UTV's. Mainly for the Kawasaki Mule, Kubota RTV900/1100, and Yamaha Rhino. Hardtops, Cab enclosures, Windshields (plastic and glass), Lift Kits, and Tires are our main fair.

Our SureFoot Tires are very popular and can fit many UTV and ATV's, designed with the ultimate off-road dependability in mind. Built with tough "Stubbleguard" rubber, Kevlar-Belting, Run-Flat Performance, Reinforced Sidewalls and load ratings over 1100 lbs. You won't likely get stuck again due to a punctured tire, a pinched sidewall, or just plain insufficient traction.

We have three sizes available for our SureFoot's: 25, 26, & 27 inch. The 25 and 27's have a 589MT tread pattern, and the 26's have a 489XT pattern.

Also, our Plastic "Snap-On" Windshields are very popular: economical, and a "no tools required" installation. Snap it on in less than a minute. It can also be trailered at normal highway speeds (in a forward position). Or upgrade to our openable Lift-Glass Windshield, it features the durability of Lexan in the lower panel and tempered Safety Glass in the upper. Drive with it open or closed, and on the Mule version, the front compartment is still accessible.

Contact us for more info, if you like:
Essex Manufacturing, Inc
1(888)643-7739
http://www.essexmfg.com
[email protected]

Thanks guys for the interest and support!
See less See more
Thank you,looking forward to reading about your products and testing some.
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top