ATV Torture Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
42 Posts
Discussion Starter · #1 ·
I was going up a ditch and spun and got stuck so i pit it in 4x4 and tried to go but i had it in high and the back tires were dug in the ground in mud and gravle so the didnt spin and the belt started to smoke just for a second then
I quicly stoped. How bad is that? Its still working fine.
 

· THE ENFORCER
Joined
·
2,036 Posts
My guess is your okay. I don't think they're too hard to che though. I'm going to install a clucth kit this week so I'll let you know how hard it would be to inspect. I'd seriously consider minimizing my riding, especially that kind of riding, until the sensor problem was resolved though. (Not saying that was the issue here, just saying.)
 

· The Sheriff
Joined
·
1,822 Posts
If it started to smoke, I would say that it has left rubber residue on your clutch. I would pull it apart and check for rubber glazing on the clutch. If it's there, clean it with a light scuffing of a scotch bright fine pad.

Buster
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top