ATV Torture Forums banner
Cancel

Brute Force 650i and Prairie700 front seals

2778 Views 5 Replies 3 Participants Last post by  GRIZZLYWIZARD, 
B
My brother has a 04 Prairie 700 and i have a 08 brute force 650i. BOTH SEALS FROM THE FRONT DRIVE SHAFT TO THE MOTOR, AND FROM THE MOTOR TO THE FRONT DIFF ARE LEAKING. I WANT TO TRY AND REPLACE THE SEALS MY SELF. WONDERING IF YALL HAVE ANY TIPS, ON WHAT TOOLS ARE NEEDED, DOESN'T LOOK TO COMPLICATED BUT YOU KNOW WHAT THAT MEANS. AND IF ANY INSTRUCTIONS CAN BE GIVEN PLEASE HELP.
Reply
Save
Like
1 - 2 of 6 Posts
B
its easy

it's easy had the front drive shaft out in less than 5 minutes. i just picked up the atv, slid off the o rings on the drive shaft. and the drive shafts are held in by compression from a spring. u just press from the crank toward the diff and the drive shaft comes right out. then just pull seals and replace
Reply
Save
Like
1 - 2 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
ATV Torture Forums
A forum community dedicated to ATV owners and enthusiasts. Come join the discussion about performance, reviews, tests, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
General ATV / UTV Discussion Yamaha Forum Pictures and Videos New Member Introductions Arctic Cat Forum
Top