ATV Torture Forums banner
question
1-16 of 19 Results
  1. Yamaha Forum
    Ok, I just purchased a used power commander and have a question. I think I know the answer, but I know you guys will set me straight. I have the dyna fs installed and was wondering if the two will work together? Do I just hook up the power commander and rock on, or am I supposed to remove the...
  2. Yamaha Forum
    hey guys i was out for a little ride yesterday here in pa. boy that was a mistake because not as much snow melted as i thought. took me about an hour and a half to go maybe a mile or two. but anyways when riding in four wheel drive NO DIFF LOCK my limiter is kicking in when your on the gas. high...
  3. Electrical & Lighting
    i just bought a hid plug and play off ebay and want to install it on the LT500. i installed it on my other bike DRZ400 and it worked fine. no problems what so ever. what is needed to make it work on the LT500. do i need a relay or something. any info is appreciated.
  4. Suzuki Forum
    I have a 2008 Kingquad 450axi. I've never had a cvt machine before. I notice some sluggishness off of the line if I hit the throttle hard. It kind of drags a little then takes off. Is this normal? Would a clutch kit cure this if it is normal? What are some good clutch kits for this quad? I...
  5. Yamaha Forum
    I have heard many times about how not to snorkel your grizzly unless you expect to lose some power. I have plans to use two 2" intakes into my airbox. I dont see how it is possible for it to not get as much air as stock. If anything i would think it would get more over stock. Any opinions? Any...
  6. Yamaha Forum
    My buddy is replacing his rear axle's and it's been apart so long, he can't remember which one goes where. He needs to know what side the longer axle goes on. Anyone got the answer to that one? Thanks.
  7. Tires, Wheels, Brakes
    Can a tire get stretched????? I ask because I bought a set of used Swamp lites and rims, 12x27. I checked the air pressure and they were all a little high if you ask me, they were 10 to 14 psi. so I adjusted them to 6 psi. But here comes the confusion, When I put the tire up next to the 4...
  8. Honda Forum
    the knob that switches it from automatic to manual shift has D1,D2,and ESP. what is the difference in D1 and D2
  9. Kawasaki Forum
    i own a '90 bayou 220 that my kids have used as a starter quad. over the years, it has developed a small oil leak that i just ignored, since it was so minimal. yesterday, the leak became worse and the centrifugal clutch began acting up. when the quad wasn't in motion, it would cause the...
  10. Welcome to the ODI Grips Forum
    I would love to get a new set of grips for my Outlander and really like the ODI X-treme and Rogue Lock On Grips. I'm not familiar with lock on grips so I have to ask a dumb question. Do both of the metal pieces lock and if when selecting a color for the lock clamp, will this be the color of both...
  11. Honda Forum
    What happens when the power steering fails? I am talking specifically about the electric power steering on the Rancher. Does it affect anything other than the ease of turning. Can you still turn? Does it steer like a 4wheeler with no power steering? I am concerned about the power steering...
  12. The Lounge
    A backhoe weighing 8 tons is on top of a flatbed trailer and heading east on Interstate 70 near Hays, Kansas . The extended shovel arm is made of hardened refined steel and the approaching overpass is made of commercial-grade concrete, reinforced with 1 1/2 inch steel rebar spaced at 6 inch...
  13. General ATV / UTV Discussion
    We have been tossing around an idea with respects to plastic fade/discoloration and life span of plastic on ATVs, UTVs. We realize that replacing dulled, worn out, nasty plastic on most of these vehicles is expensive so we thought we would see how much interest might be in the following...
  14. Tires, Wheels, Brakes
    I searched but can't find anything on this, but I have a set of 26" ITP Mudlite XL's. My question is, have you guys ever seen anyone or heard of anyone flipping the direction on two of the tires? I have had people always tell me on my mud trucks that with a directional tread pattern I should...
  15. Electrical & Lighting
    For you that have PIAA lights.. Im installing my PIAA lights on my rack. When I tighten down the light to the PIAA universal bracket the light will not remain straight. In other words the name PIAA written in the light cover will be slightly crooked. If I back out the light enough to...
  16. Electrical & Lighting
    I'm sure by now that you guys are getting tired of my rookie questions, but how else is an idiot supposed to become smart? Consider this set up: 07 Grizz 660 26" Tires 12" ITP SS Rims 4x450 weights Dynojet Kit UNI Filter Exhaust Tip In your opinion(s) would a CDI box help me any more? If it...
1-16 of 19 Results
Top