AAEN exhaust

maknpower · #1 (**permalink**) 09-26-2010, 09:56 PM

I just installed the exhaust on my renegade, I love the sound but where the clamp goes on to attach it to the existing pipe it is still loose and I have tightened it down all the way, the bolt that holds the exhaust to the frame is tight so it can not move around but I am still concerned about the clamp connection. Will it tighten up once everything gets hot, is this normal, any feed back appreciated.

Oldviolin501 · #2 (**permalink**) 01-31-2011, 08:53 AM

I have the aaen slip-on on my 09 outlander, I have the same problem with it being loose but sofar so good and it don't leak. I'll update if I have problems from there

**1Bad1000Xxc** · #3 (**permalink**) 02-02-2011, 11:48 PM

I have the AAEN on my Renegade and my friend has it as well. You have to tighten the absolute snot outta that clamp, to the point where you think it is gonna brake, BUT DON'T DO THAT. Once you do that, Tighten the rear bolt until the silencer doesn't budge at all. You will be good to go then with worries of leaks. I love my AAEN and haven't heard anything that sounds anywhere near as good on a Can-Am. It's not too loud, gives great power, and sounds bad ass.

Buster