Quote:
Originally Posted by jwtindall
Whats up. I got a 2005 Arctic Cat 650v Twin and i need to find out how to reset the belt light. Can anyone please tell me this simple procedure that i can't figure out.
|
This goes un-tested. I would get a service manual, but feel free to try it.
1.With ignition Key in the OFF position - Belt cover side of quad.
2.Unplug belt sensor (2 wire)(flat connector) and the 4 wire harness (square connector) next to it (black connector)
3.Jumper the orange/green wire to the gray (possibly gray/green) wire right next to it in the connector.
4.Turn the Key ON (Belt light should flash rapidly then flash slow) Do not turn the key off until slow flashing light occurs. Whole procedure takes about 10 seconds.
5.Turn Key Off
6.Plug in all connectors that were unplugged to do the reset procedure.
7.Turn Key ON to verify reset (If belt light flashes you either need to take you bike in for the recall on voltage spikes in the CDI circuit)
